Publicité
Les langues disponibles
Les langues disponibles
MN008454A01-AB
Chapter 4 : Charger Overview
Status
Fault
Standby
•
Battery is waiting to rapid
charge.
•
Battery is too hot, too cold,
or low voltage.
•
Charger is too hot.
Table 10: Charging Indications for IMPRES 2 Battery Calibration-Calibration Required, but not Enabled
Status
Charger Powers On
Battery Detected
Requesting IMPRES 2 Battery
Calibration
•
Calibration is disabled in
charger.
•
Battery is charging
Rapid Charging
•
Request for Calibration
time-out
24
Charger Display
WARNING: NOT
CHARGEABLE RE-
MOVE & REINSERT
WARNING: HOT
BATTERY WAITING
TO CAL or COLD
BATTERY WAIT-
ING TO CAL or
VERY LOW BAT-
TERY WAITING TO
CHRGE or HOT
CHARGER WAITING
TO CAL
Charger Display
IMPRES 2 CHARGER
IMPRES 2 BATTERY
WARNING: ENABLE
BATTERY CALI-
BRATION?
•
Press OK to ena-
ble calibration.
•
Ignore for normal
charging (mes-
sage disappears
after one minute).
RAPID CHARGE xxxx0mAh
yyy%Ptl
LED Indicator
from the fleet: Blinking Red
and Green
NOTE: Applicable
for APX NEXT XN
battery.
Blinking Red
Blinking Amber
LED Indicator
Green for approximately one
second
Battery requires calibration,
but calibration is disabled in
charger: Alternating Amber
and Green for four seconds.
Steady Red
Steady Red
Publicité
