Keysight U2761A Mode D'emploi page 96

2 Features and Functions
Set Triggering Using SCPI Commands
Example 1
-> *CLS; *RST
-> FUNC SIN
-> VOLT 5 VPP
-> VOLT:OFFS 0
-> SWE:STAT ON
-> FREQ:STAR 500
-> FREQ:STOP 10000
-> SWE:SPAC LIN
-> SWE:TIME 2
-> TRIG:SOUR IMM
-> OUTP:TRIG ON
-> OUTP:TRIG:SLOP POS
-> OUTP ON
96
// To reset the Keysight U2761A to default
power-on state, this command can be
ignored if this operation is not required.
// Sets the carrier waveform to Sine wave.
// Sets the output amplitude to 5 Vpp.
// Sets the output offset to 0.
// Enables frequency sweep.
// Changes the start frequency to 500 Hz.
// Changes the stop frequency to 10 kHz.
// Changes the sweep mode to Linear.
// Changes the sweep time to 2 s.
// Changes the sweep trigger source to
Internal.
// Turns on the trigger output.
// Outputs the trigger on a rising edge.
// Turns on output.
Keysight U2761A User's Guide