Keysight U2761A Mode D'emploi page 62

2 Features and Functions
Soft Front Panel Operation
Click Mod
FM waveform, configure the settings for the carrier frequency, output amplitude,
offset voltage, modulating frequency, deviation, and the desired waveform.
Figure 2-18
Remote Interface Operation
Carrier Waveform
The FM carrier waveform consists of Sine, Square, Ramp, Triangle, or Arbitrary
waveform. The default waveform is Sine wave. You cannot use Pulse or DC as the
carrier waveform.
Soft Front Panel Operation
For Arbitrary waveforms, select Arb
Figure 2-2
as shown in
Remote Interface Operation
You can also use the APPLy command to select the function, frequency,
amplitude, and offset.
62
and then select FM
Panel view of FM
FM:STATe {0|OFF|1|ON}
and select the desired waveform from the drop down list
Figure 2-16.
FUNCtion {SINusoid|SQUare|RAMP|USER}
as shown in Figure 2-18. To output the
at the top panel as shown in
Keysight U2761A User's Guide