Keysight U2761A Mode D'emploi page 71

Phase Deviation
The phase deviation setting represents the peak variation in phase of the
modulated waveform from the carrier waveform. The phase deviation setting can
be set from 0 to 360. The default phase deviation setting is 180.
Soft Front Panel Operation
On the Phase Deviation panel as shown in
deviation value.
Remote Interface Operation
Generate PM Using SCPI Commands
Example 1
-> *CLS; *RST
-> PM:STAT ON
-> FUNC SIN
-> FREQ 1000
-> VOLT 5 VPP
-> VOLT:OFFS 0
-> PM:INT:FUNC SIN
-> PM:INT:FREQ 500
-> PM:DEV 180
-> OUTP ON
Keysight U2761A User's Guide
PM:DEViation <deviation in degrees>
//To reset the Keysight U2761A to default
//Enables PM.
//Sets the carrier waveform to Sine wave.
//Sets the carrier frequency to 1 kHz.
//Sets the output amplitude to 5 Vpp.
//Sets the output offset to 0.
//Changes the modulating waveform shape
//Changes the modulating frequency to
//Changes the phase deviation to 180.
//Turns on output.
Features and Functions
Figure 2-20, input the desired phase
power-on state, this command can be
ignored if this operation is not required.
to Sine wave.
500 Hz.
2
71