Sabo 54-PRO K VARIO PLUS Livret D'entretien page 72

Before you start mowing, always check the grass collecting equipment for wear or loss of functionality.
Before you start mowing, always check the condition and firm attachment of the cutting blade. The blade
attachment screw must always be tightened by an authorised workshop. If the blade screw is too tight or too
loose, the blade coupling and cutter bar can become damaged or loose which can lead to serious injuries. A
worn or damaged blade must always be replaced.
Changing, regrinding and balancing the cutting blade must be carried out by an authorised professional workshop.
A wrongly assembled cutting blade coupling can allow the cutting blade bar to get loose and cause severe injuries.
An improperly ground and imbalanced cutting blade can cause strong vibrations and damage the lawn mower.
• Make sure that the spark plug connector is firmly seated! Touching is only a risk if the spark plug connector is not
installed correctly.
• For reasons of safety, always replace worn or damaged parts.
Protective gloves must be worn at all times during maintenance and cleaning work.
Maintenance and cleaning work must only be carried out if the engine has been turned off and the spark plug
connector has been removed.
• Never remove the spark plug connector when the motor is running! Risk: Electric shock.
• If the tank has to be emptied, this should be done in the open, and with a cold engine. Take care to ensure that no fuel
is spilt.
For warranty and safety reasons, original replacement parts must be used at all times.
6 DESCRIPTION OF COMPONENTS
1 Safety control bar for engine or blade brake (model-dependent)
2 Vario actuation lever
3 Drive control bar
GB
4 Tank cap with ventilation valve
5 Engine cover
6 Fuel tap
7 Air filter
8 Oil filter
9 Spark plug
10 Cutting height setting
11 Carrying handle
12 Protection frame
13 Exhaust protection grid
14 Belt drive covers
15 Oil-refill neck with dipstick
16 Ejection flap
17 Starter cable handle
18 Control panel
19 Switch-on lever for cutting unit (model-dependent)
20 Actuation lever for engine
7 PREPARATION
The following unit parts are included in the mower assembly package:
• Mower with preassembled protective frame
• Guide tube – bottom part (inside below bottom cushion)
• Guide tube – top part with operating panel
• Grass catch, collection bag frame
• Tool bag with the following content:
– Operating manual with Conformity declaration
– Guarantee card and guarantee conditions
– Spark plug spanner
All manuals and user guides at all-guides.com
8