Sabo 54-PRO K VARIO PLUS Livret D'entretien page 79

Converting the machine to rear ejection (Illustration U2 + S1 )
– Stop the engine.
– Lift up the ejection flap.
– Remove the mulch stopper from the duct U2 .
– Hang the grass collection bag in the provided holder on the mower housing S1 .
Conversion of the mulch blade system is not required! Under difficult mowing conditions (e.g. wet grass) a reduced filling
level of the collection bag can result.
In order for the equipment be used once again as muIch mower, the muIch stopper must be installed again. To do this,
remove the grass collection bag, introduce the muIch stopper in the ejection duct and close the ejection flap.
16 GRASS COLLECTOR
Operation with grass collector
During mowing ensure that the collector is emptied in good time. The turbo indicator on the collector will indicate when the
collector should be emptied. A deflector (available as an accessory from dealers under the Order No. SA592) can also be
fitted in place of the grass collection bag.
IMPORTANT
Make sure that the chute (1) R1 is not bent when handling the collector.
Turbo signal (shows when the grass collector is full) (Illustration J + K )
There is an indicator on the top of the collector that shows whether the collector is empty or full:
The collector indicator inflates if the collector is empty and during the mowing J .
–
If the collector is full, the indicator collapses; once this happens, stop mowing immediately and empty the collector K .
–
IMPORTANT
If the fabric of the grass collector is very dirty the turbo indicator will not inflate – in this case, clean the fabric
immediately. The grass collector will only collect grass perfectly if it is permeable to air.
IMPORTANT
Do not clean the grass collector with hot water!
Emptying the grass collector
Model with engine brake (Illustration L )
– Stop the engine.
– Lift the ejection flap.
– Unhook the filled grass collecting bag by the handle – the ejector flap closes automatically.
– Hold the collecting bag firmly by the handle and the recess on the bottom and shake thoroughly L .
Model with blade brake (Illustration I3 + L )
Release the safety control bracket I3 . This will bring the blade brake into operation, bringing the blade to a standstill within 3
seconds. With the engine running, the collector bag can now be emptied as follows:
– Lift ejection flap.
– Unhinge the full grass collector from the mower at the carrying strap – the ejection flap closes automatically.
– Empty the collector thoroughly whilst holding it by the carrying strap and the moulded handle on the bottom L .
Operation without grass collector
WARNING
When mowing without grass collector the ejection flap on the mower housing must always be closed (flap down).
All manuals and user guides at all-guides.com
15
Safety instruction!
See table for explanation of symbols page 3
GB