Télécharger Imprimer la page

Fimar CAM300 Emploi Et Entretien page 35

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
CONTROL PANEL LEGEND
1
15
5
1
Control panel with thermo-forming buttons.
ON/OFF button
2
the machine discharges. The LED signals the presence of supply voltage.
HEAT PUMP button,
PUMP" appear on the display. The pump runs for about 15 sec. which is the warm-up time.
EXTRA VAC button,
3
During this cycle the words "EXTRA VACUUM" appear on the display. This cycle lasts 5 sec.
STEP VAC button, to switch the pause/work cycle on and off
4
During the pause cycle the words "PAUSE VACUUM" appear on the display dividing the entire
vacuum cycle into 4 parts with a pause for foaming products.
VAC TIME button, the vacuum time appears on the display
5
seconds, the programming mode is activated and the number will blink on the display. Once the
time has been changed, the new time is confirmed by pressing this button (recommended average
time is 30/32 sec.).
SEAL TIME button, the sealing time appears on the display. If this button is pressed for 2
6
seconds, the programming mode is activated and the number will blink on the display.
Once the time has been changed, the new time is confirmed by pressing this button
(average sealing time is between 3 and 5 sec. depending on the materials used).
GAS TIME button,
7
seconds, the programming mode is activated and the number will blink on the display.
Once the time has been changed, the new time is confirmed by pressing this button
(average gas injection time is between 6 and 8 sec.).
GAS ON/OFF button,
8
PROG AUT button,
9
number of the programme selected appears on the display. It is possible to select a « free »
programme by pressing this button a second time.
-
10
button (minus), decreases the value that appears on the display.
11
+ button (plus), increases the value that appears on the display.
12
LCD DISPLAY. The LCD display shows the various machine operating phases and the vacuum
percentage relating to the preset time that the machine attains. It is also possible to pre-select the
required vacuum percentage excluding the preset vacuum time by setting the relevant parameter.
CAM300-400-500-520C-700C-900C
13
2
6
5
7
16
, to switch the machine on and off. If this button is pressed during the work cycle,
to switch the vacuum pump on and off. During this cycle the words "HEAT
to switch the extra vacuum time on and off. The LED signals this function.
the gas injection time appears on the display
to switch the gas cycle on and off. The LED signals this function.
selects one of the ten preset programmes. The LED signals this function. The
11
4
9
8
. The LED signals this function.
. If this button is pressed for 2
. If this button is pressed for 2
12
14
10
3

Publicité

loading