Fimar CAM300 Emploi Et Entretien page 27

CHAPTER 3
WARRANTY
The manufacturing company engages, for 12 (twelve) months from the date of shipment and
direct delivery of the goods, to assure the customer or concessionaire the integrity and the good
working of the components regarding the above mentioned machine.
All machine components normally subject to wear, that is to say components in which use causes
a constant wear and tear, are not included in the warranty:
A. Electrical resistances – Teflon – Rubber gaskets – Chamber opening pistons – Sealing diaphragms – Air
filters – Oil filters – Oil change – Pump blades.
B. If the vacuum pump of a machine under warranty is sent to the manufacturing company because of
aspiration problems and malfunction, the manufacturing company has the right to check whether any
foreign bodies have been aspirated (liquids, solids, sauces, etc..). If this should be the case, the repair
(materials and the labour) will be duly charged, since the problem is not due to manufacturing defects,
but to customer negligence during use.
C. Possible problems linked to the electronic panel cards of the circuit will have to be examined by the
manufacturing company before sending the part which has to be replaced under warranty. A sudden
change in voltage, an electrical overfeeding, a disturbance in the external current network, could cause
damages which are not to be attributed to the manufacturing company.
D. Possible problems with pneumatic, structural, mechanical parts will be duly solved as per warranty terms
without any charge.
E. During the warranty period, for interventions under warranty, the replaced materials will not be charged,
while the labour will be duly charged. During the warranty period, for interventions not included in the
warranty for various reasons, both the materials replaced and the labour will be duly charged.
F. During the warranty period, should any external intervention of our technicians be requested, the travel
costs (to and from) will be fully charged independently of the reason behind the intervention.
G. Any interventions on the machines are to be carried out at the manufacturer's premises both during the
warranty period and after the warranty period; we point out that no transport costs (to and/or from) will
be refunded.
H. The transport for any materials sent to the manufacturing company, both during the warranty period
and after the warranty period, must compulsorily take place in ex works.
I. Any materials sent to the manufacturing company with transport charges will be automatically refused.
J. Any components considered defective (pump, electronic panel card, etc..) and mishandled by the
customer during the warranty period will not be considered under warranty. The manufacturing
company has the task of carrying out this function in a strict manner.
Do not remove the "CE MARKING" plate and/or replace it with a different one. Should the "CE
MARKING" plate be accidentally damaged, detached from the machine or the manufacturer's seal
removed, the customer must compulsorily and immediately inform the manufacturing company.