Parker Antares ATT060 Manuel D'utilisation page 24

English
Y
** Refer to the manufacture date of the machine, written in the
data label.
Maintenance work must be performed by authorized personnel.
All spare parts and their respective codes can be found listed on
section 9.4.
Z
Contact supplier
For any maintenance please note the following warnings:
During the replacement of any fi lter element, ensure the perfect closing
of the fi lter, checking the correct alignment of symbols on the head and
the housing.
!
DANGER: A misalignment of these, could result in the expulsion of
the housing during pressurization of the system, with the consequence
of projection hazard of bodies against persons of things.
!
DANGER MACHINE UNDER TENSION
Not perform maintenance while the machine is under tension or under
pressure.
Do not remove any covers of the dryer.
!
DANGER HAZARDOUS VOLTAGE!
!
DANGER MACHINE UNDER PRESSURE
!
Not perform maintenance while the machine is under pressure,
perform the following action:
1) Depressurize the compressed air system;
2) Make sure that the pressure on both gauges = 0 bar
(AIR IN "n°22");
!
Warning: the dryer is still under pressure in the
"AIR OUTLET SIDE" of the cooler
Depressurize the dryer using a valve- "air out cooler"
3)
(if installed by the user) or use the drain-valve of the
dust-fi lter (29).
Make sure that the pressure on gauge = 0 bar
4)
(AIR OUT "n°35").
ATT060-090
!
The desiccant vessels are designed (EN 13445-3) for fatigue
operation with continuous cycles of loading and unloading for a
maximum period of:
20 years for models 60-90.
6.5 Dismantling
The refrigerant and the lubricant oil contained in the circuit must be re-
covered in conformity with the current local environmental regulations.
The refrigerant fl uid is recovered before fi nal scrapping of the equipment
((EU) No. 517/2014 art.8).
• %
Recycling Disposal
Structural work steel/epoxy-polyester resins
exchanger alluminium
pipes alluminium/copper/steel/iron
drain polyamide
exchanger isolation EPS (sintered polystyrene)
pipe isolation synthetic rubber
compressor steel/copper/alluminium/oil
condenser steel/copper/alluminium
Refrigerant R407c
Valves brass
electrical cables copper/PVC
vessel steel/epoxy resins
fi lter vessel steel/epoxy resins
fi lter elements contact supplier
valve blocks alluminium
dessicant agent contact supplier
Equipment containing electrical components
must be disposed separately collected with
electrical and electronic waste according to
local and currently legislation.
Z
8 / 14