Franke FMY 45 CM Manuel D'installation Et D'utilisation page 15

Fig. 28 Fig. 29
Installing the filter
Some models are fitted with a water softener filter to
improve the quality of the water used and extend the
working life of the appliance.
To install, proceed as follows:
Remove the filter (A9) from the packaging
X
(see page 8)
Slide the date indicator pointer (see Fig. 37)
X
until the months of use are displayed.
Fig. 32 Fig. 33
Fig. 36 Fig. 37
IMPORTANT
– The filter lasts about two months if the appliance
is used normally.
– If the coffee maker is left unused with the filter
installed, it will last a maximum of three weeks.
– Fill the tank with a little water up to the level
shown in the figure:
Insert the filter in the water tank and press it until
X
it touches the bottom of the tank (see Fig. 37);
Place the hot water spout if it is not there.
Fill the water tank and place it in the coffee
X
maker, then insert the hot water spout (C7)
(see page 8).
Position a container under the spout
X
(min. capacity: 100 ml).
Press the icon (B2) to enter the menu.
X
Press the icons
X
FILTER" is displayed.
Press the icon (B9).
X
The message "INSTALL FILTER PLEASE CONFIRM"
X
is displayed.
Press the icon (B9) to confirm the selection
X
(or (B6) to cancel). "HOT WATER PRESS OK"
is displayed.
Fig. 30
Fig. 34
12
1
2
3
4
5
6
7
8
9
10
11
12
1
Fig. 38
(B7) and (B8) until "INSTALL
2
FMY 45 CM
Fig. 31
Press the
X
delivering hot water and the message "PLEASE
WAIT... " is displayed.
When delivery stops, the appliance automatically
X
displays the basic modes set again.
Fig. 24
IMPORTANT
– The appliance may request the operation to
be repeated a number of times until the air is
Fig. 35
completely elminated from the hydraulic circuit.
Replacing the filter ("Filter reset")
When "REPLACE FILTER" is displayed or after
2 months of use (see date indicator), the filter must
be replaced:
Remove the exhausted filter.
X
Fig. 28
Remove the new filter from the packaging.
X
Slide the pointer of the date indicator (see Fig. 37)
X
until the months of use are displayed (the filter
Fig. 39
lasts about 2 months).
Insert the filter in the water tank and press it until
X
it touches the bottom of the tank (see Fig. 37).
Fill the water tank and place it in the coffee
X
maker, then insert the hot water spout (C7)
(see page 8).
Fig. 32
Fig. 36
Position a container under the spout
X
(min. capacity: 100 ml).
Press the
X
Press the
X
RESET" is displayed.
Press the OK icon (B9).
X
The message "FILTER RESET CONFIRM" is
X
displayed.
Press the
X
(or (B6) to cancel). "HOT WATER PRESS OK" is
displayed.
Press the
X
The appliance begins delivering hot water and the
X
message "PLEASE WAIT..." is displayed.
When delivery stops, the appliance automatically
X
displays the basic modes set again.
– 15 –
icon (B9) again. The appliance begins
Fig. 25 Fig. 26
Fig. 29 Fig. 30
Fig. 33 Fig. 34
12
1
2
3
4
5
6
7
8
9
10
11
12
1
Fig. 37 Fig. 38
icon (B2) to enter the menu.
icons (B7) and (B8) until "FILTER
icon (B9) to confirm the selection
icon (B9) again.
EN
Fig. 27
1
2
Fig. 31
Fig. 35
Fig. 39