Franke FMY 45 CM Manuel D'installation Et D'utilisation page 13

Fig. 3
Position the rails on the sides of the cabinet as
X
shown in the Figure 4. Fix with the screws supplied,
then extract them completely. If the coffee maker
is installed over a warmer drawer, use the top
surface of this as a reference to position the rails.
In this case, there will be no surface to rest the
rails on.
x 16
Fig. 4
Position the appliance on the rails, making sure the
X
pins are correctly inserted in the housings, then fix
it with the screws supplied (Fig. 5). If the height of
the appliance requires adjusting, use the spacer
disks provided.
x 1
x 2
x 16
x 1
x 16 x 2
x 2
x 1
FMY 45 CM
Fig. 5
Fix the power cable with the clip (Fig. 6). The
X
power cable must be long enough to allow the
appliance to be extracted from the cabinet to fill
the coffee bean container.
x 4
Fig. 6
x 4
IMPORTANT
The appliance must be earthed in compliance
X
with legislation.
Electrical connections must be performed by
X
a qualified electrician following the instructions.
If necessary, correct alignment of the appliance
X
by positioning the spacers supplied under or at
the sides of the support (Fig. 7).
Fig. 7
x 4
The rail fixing panel must have a thickness suited
X
to the fixing screws provided.
The panel material must be suited to the machine
X
weight of approximately 25 kg.
– 13 –
x 4 x 8
x 16 x 2
x 1
x 4
x 8
x 8
x 4
EN
x