Franke FMY 45 CM Manuel D'installation Et D'utilisation page 28

EN
FAULT
The milk does not come out
of the milk spout (C5).
The milk is not well frothed. The milk container lid is dirty.
The milk contains bubbles
or squirts out of the milk
spout.
TECHNICAL DATA
The data plate on the side of the appliance states the
total load when connected, the required voltage and
frequency.
Please check the minimum measures necessary to
the proper installation of the appliance. The coffee
maker must be installed in a column unit, which must
in turn be fixed to the wall.
FMY 45 CM
CAUSE
The intake tube is not inserted or
is inserted incorrectly.
Fig. 24 Fig. 25
Fig. 28 Fig. 29
The frothed milk regulatoris not
positioned correctly.
The milk is not cold enough or is
Fig. 32 Fig. 33
not semiskimmed.
The frothed milk regulator is
incorrectly adjusted.
Fig. 36 Fig. 37
The milk container lid is dirty.
– 28 –
SOLUTION
Insert the intake tube (C4) in the rubber
washer in the milk container lid (Fig. 31).
Fig. 26
1
2
Fig. 30
Clean the milk container lid as described
in the section "Cleaning the milk
container".
Adjust following the instructions in the
section "Making cappuccino".
You should ideally use skimmed or
Fig. 34
semi-skimmed milk at refrigerator
12
1 temperature (about 5°C). If the result is
2
3
4
5
still disappointing, try another brand of
6
7
8
9
10
milk.
11
12
1
Move the frothed milk regulator slightly
towards the word "CAFFELATTE"
(see section "Making cappuccino").
Fig. 38
Clean the milk container lid as described
in the section "Cleaning the milk
container".
Voltage: 220-240 V~ 50-60 Hz max. 10A
Absorbed power: 1350 W
Pressure: 1,5MPa (15 bars)
Water tank capacity: 1.8 litres
Size L x H x D: 595 x 456 x 412 mm
Weight: 26 kg
Fig. 27
Fig. 31
Fig. 35
Fig. 39