Franke FMY 45 CM Manuel D'installation Et D'utilisation page 12

EN
INSTALLATION
Controls after transport
After removing the packaging, make sure the product
is complete and undamaged and that all accessories
are present. Do not use the appliance if it is visibly
damaged. Contact Customer Services.
Installing the appliance
IMPORTANT
Installation must be performed by a qualified
X
professional in compliance with legislation in
force in the country of installation (see Built-in
installation).
The packing elements (plastic bags, polystyrene
X
foam, etc.) should be kept out of reach of
children.
Do not install the appliance in rooms where the
X
temperature may drop to 0°C or lower.
Customise the water hardness as soon as
X
possible following the instructions in the "Setting
water hardness" section.
Connecting the appliance
DANGER!
Check that the mains power supply voltage
X
corresponds to the value indicated on the rating
plate on the bottom of the appliance.
Connect the appliance to an efficiently earthed
X
and correctly installed socket with a minimum
current rating of 10A only.
If the power socket does not match the plug on
X
the appliance, have the socket replaced with
a suitable type by a qualified professional.
To comply with safety directives, an omnipolar
X
switch with a minimum contact distance of 3 mm
must be installed.
Do not use multiple sockets or extensions.
X
IMPORTANT: Safety cutout devices must be
included in the mains power supply in compliance
with the installation regulations in the country
concerned.
FMY 45 CM
Built-in installation
Verify the minimum measurements required for
X
correct installation of the appliance (Figure 1, 2
and 3).
The coffee maker must be installed in a column
X
and the column must be firmly fixed to the wall
with commercially available brackets.
Fig. 1
Fig. 2
IMPORTANT
All installation or maintenance operations must be
performed with the appliance disconnected from
the mains electricity supply.
Kitchen furniture in direct contact with the
appliance must be heat resistant (65°C min).
To guarantee correct ventilation, leave a gap at
the bottom of the cabinet (see measurements in
(Figure 3).
– 12 –