Franke FMY 45 CM Manuel D'installation Et D'utilisation page 17

After a few seconds, the appliance is ready for
X
use again.
Fig. 16 Fig. 17
To turn the appliance off, press the On-Off/stand-
X
by button (A7) (see page 8). (Before going off,
the appliance performs an automatic rinse cycle.
Take care to avoid scalds).
Note: If the coffee is delivered a drop at a time
or not at all, see the "Adjusting the coffee mill"
section.
Fig. 20 Fig. 21
Note: If the coffee is delivered too fast and the
cream is not satisfactory, see the "Adjusting the
coffee mill" section.
Tips for a hotter coffee
– When you turn the appliance on, if you want to
make a small cup of coffee (less than 60 ml),
preheat the cup by rinsing it with hot water.
– If on the other hand more than 2/3 minutes have
passed since the last coffee was made, before
requesting another coffee, you must preheat
the brewing unit by pressing the
Deliver the water into the underlying drip tray or
alternatively use this water to fill (and then empty)
the cup to be used for the coffee to preheat it.
– Unless preheated, do not use excessively thick
cups as they will absorb too much heat.
– Preheat the cups by rinsing them with hot water.
– Coffee delivery can be interrupted at any moment
by re-pressing the previously selected icon which
remains lit during the operation.
– As soon as delivery is finished, to increase the
quantity of coffee in the cup, just keep pressing
the previously selected icon within 3 seconds
after delivery has finished.
– When the appliance displays "FILL TANK", fill the
tank with water or the appliance will not deliver
coffee. (It is normal for there to be a little water
left in the tank).
Empty the waste coffee container
After about 14 single (or 7 double) coffees, the
appliance displays "EMPTY WASTE COFFEE
CONTAINER". Even if not full, the empty waste coffee
container message is displayed 72 hours after the
first coffee has been delivered. For the 72 hours to
be calculated correctly, the machine must never be
turned off with the main switch in the 0 position.
To clean, open the service door on the front of the
X
appliance by pulling the spout (Fig. 23), extract
the drip tray (Fig. 24) and clean (Fig. 39).
FMY 45 CM
When cleaning, always extract the drip tray
Z
completely.
Fig. 18 Fig. 19
Fig. 22 Fig. 23
icon (B3).
the waste coffee container MUST always be
emptied. If this is not done, the machine may be
clogged.
Note: Never extract the water tank while the
machine is delivering coffee.
If it is removed, it will not be possible to make the
X
coffee and the appliance will display "GROUND
TOO FINE ADJUST MILL AND PRESS OK" and then
"FILL TANK!".
Check the level of water in the tank and replace in
X
the appliance.
To use the appliance again, insert the hot water
X
spout (Fig. 13) if not already in position, press
the
displayed. Press the
seconds and deliver water from the spout for
about 30 seconds. When delivery stops, the basic
modes are displayed again.
Fig. 8
Fig. 12
– 17 –
Fig. 39
CAUTION: When extracting the drip tray,
icon (B9). "HOT WATER PRESS OK" is
icon (B9) within a few
Fig. 9
Fig. 13
EN
Fig. 24 Fig. 25
Fig. 28 Fig. 29
Fig. 32 Fig. 33
Fig. 36 Fig. 37
1
Fig. 10 Fig. 11
Fig. 14 Fig. 15