Brill 40 VB Mode D'emploi page 16

accidents that occur involving
other people or their property.
GB
5. Proper Use
The Brill lawn aerator is designed
for working on lawns and grass-
land in private house and hobby
gardens and is not designed for
industrial use in public green
spaces, parks, sporting locations,
alongside roads and in the
agricultural and forestry sectors.
6. Assembly
Checking all the Parts are Included:
The box contains the following
parts:
Complete Petrol Lawn Aerator
.
Spark plug spanner
.
Operating instructions
.
Fitting the Guide Handle
The Brill lawn aerator packed in
a pre-assembled state. Remove the
implement from the packaging,
pull the Z-shaped, folded drag links
apart and tighten the cross-tie
7. Putting into operation
Before use, always carry out
a visual inspection in order to
determine whether the cutting tools,
fixing bolts and the complete cut-
ting unit are worn or damaged.
A worn or damaged cutting tool
should always be replaced in order
to avoid an imbalance (see:
Maintenance, Care and Storage).
Only aerate during daylight or
with good artificial lighting. The
use on wet grass is to be avoided
where possible. Always ensure that
the implement is well and securely
positioned on inclines.
Only move the implement at walk-
ing speed. Take special care
when turning the aerator around or
pulling it in your direction. Bring
16
All manuals and user guides at all-guides.com
Keep these operating instructions
in a safe place.
Adherence to the instructions for
use enclosed by Brill is a precondi-
tion for the proper use of the equip-
ment. The instructions for use also
include the operating, care and
maintenance instructions.
tension handle in position (fig. A
pos. 1).
Allow the drag links to engage at
the required height and screw it
firmly to the hinged tension handle
to the left and right (fig. A pos. 2).
Warning! Ensure that you
A
do not trap the cable and
Bowden cable (fig. A pos. 8).
the cutting tool to a halt if it should
be necessary to tilt the implement
for transportation across surfaces
other than grass and if the aerator
has to be moved from and to the
surfaces which are to be worked on.
Never use the aerator with
damaged protective devices or
protective gratings or if protective
devices, e. g. impact plates
and / or grass collectors.
Warning! The safety devices
A
mounted on the implement
by the manufacturer are neither
to be removed nor are they to be
bypassed as this could result in
a risk of injury, it also being pos-
sible that the implement no longer
automatically deactivates.
Warning! Due to a risk of
A
injury, the implement is not
to be used as a motor hoe and for
the levelling out of uneven patches,
such as molehills.
Suspending the starter cable
Pull the starter handle (fig. B
pos. 11) at the motor and suspend
the starter cable in the holding
device on the guide bar from
underneath as shown (fig. B).
Protection of the environment,
disposal
The packaging material
is made ao recyclable
materials. Dispose of
packaging materials in accordance
with regulations.
When the engine is running, keep
your hands and feet out of the way
of the interior housing and grass
discharge.
Always wear closed footwear and
long trousers. Do not aerate when
barefoot or wearing light sandals.
Do not change the controller setting
of the engine and do not overturn
the controller.
Warning! The motor is
A
delivered without any oil
in the crank housing. Therefore,
before use it is imperative that the
motor crank housing be filled with
10 W 30 motor oil. To do so,
place the appliance in a horizontal
position and clean the area sur-