Locking Rims With A Center Hole Of 164Mm; Locking Rims With A Center Hole Of 135 ~ 167Mm; Modéle: Monty 3650_ De-En-Fr_Release December 2018 - Hofmann monty 3650 Manuel De L'opérateur

5.2 LOCKING RIMS WITH A CENTER HOLE OF 164 MM
To lock this type of rims it is required the appropriate
star flange #4020798 supplied on demand.
A. Remove the 280mm flange from the chuck as
shown in Fig.21.
Fig.21
B. Lock the rim with the 164mm star flange, as
described in section 5.1.
HOFMANN behält sich das Recht zu Änderungen ohne Vorankündigung vor _ HOFMANN reserves the right of modification without notice _ Document non contractuel
monty 3650
Betriebsanleitung Operator's Manual Notice d' utilisation
306
Modéle: monty 3650 _DE-EN-FR_ Release December 2018
5.3 LOCKING RIMS WITH A CENTER HOLE OF 135 ~ 167
MM
To lock this type of rims it is required the cone flange
# 4021247 supplied on demand.
A. Mount the spacer ring onto the chuck (Fig.22).
Fig.22
B. Lock the rim with the cone from outside following
the same procedure described in section 5.1
(Fig.23).
267
Fig.23
35
266