Cub Cadet XR2-1000 Manuel D'utilisation page 26

A. Make a good start
Before you begin, walk along the edge
of your lawn and plan how to set up the
Perimeter Wire. Take
note of all obstacles
and slopes.
Pull out approx. 30 cm (1 ft) of wire through the hole in the
spool's plastic covering and peg the beginning of the wire to the
ground where you intend to install your Base Station.
Once a tail is made, put the
first peg into the ground to
secure the end of the wire
Start unwinding the wire counter-clockwise around the lawn,
starting at the Base Station's location.
Lay it loosely along the perimeter as you walk along the lawn
edge. If you get to any area/object that needs special care,
make sure you carefully lay the Perimeter Wire as described in
the following sections.
26
Perimeter
Wire
Peg