Cub Cadet XR2-1000 Manuel D'utilisation page 74

Troubleshooting
Message
Displayed
E1
"Stuck In Place"
E2
"Cross Outside"
E3
"No Wire Signal"
E4
"Check Power"
E5
"Check Mow
Height"
74
Probable Corrective
Cause / Event Action
The mower got stuck in Check the ground for holes or
place. It cannot continue indentations. Fill it with some earth.
driving.
Check if the Perimeter Wire is not
too close to the edge. Move the wire
towards the inner side of the lawn.
The Perimeter Wire is Move the wire towards the inner side
too close to the edge. of the lawn.
The lawn slope near Do not include areas with very steep
the edge is too big and slopes.
causes the mower to slip
outside.
The lawn's edge is too Fill holes and pits along the edge till
bumpy. level with the ground.
The Power Supply is Make sure the Power Supply is
unplugged or there is a connected to the mains supply.
temporary power cut.
Signal generator may Disconnect the Power Supply from the
need to be restarted. mains supply and reconnect after 10
seconds.
The Perimeter Wire is Check the connection of the Perimeter
not connected to the Base Wire to the Base Station. Make
Station. sure the plot connector is properly
mounted.
The Perimeter Wire is cut. Check for cuts in the Perimeter Wire.
There is a temporary Check main power supply to the
power cut. Power Supply.
The Power Supply is not Confirm the Power Supply is plugged in.
plugged in properly.
There is no charging Clean the charging contacts on the Base
source detected. Station and verify proper connection of
the Base Station to the Power Supply.
The mowing system is Switch off the Safety Switch and
in overload due to very inspect the blades. Remove any foreign
tall grass or an obstacle object or excessive clogging inside the
that is stuck or wrapped mowing deck.
around the blade.
Raise the mowing height and switch
the TurboMode on.