Publicité
Les langues disponibles
Les langues disponibles
AVOID PERSONAL INJURY
It is forbidden pairs or uses centring and clamping accessories other than those speci-
fied in the "tables for using centring and clamping accessories according to rim type"
When working with "easily deformable" rims (i.e. a
central hole with thin, projecting edges - see Fig.
16) we recommend using the universal turntable for
blind rims (see the section "TABLE FOR USING cEN-
TRING AND cLAMPING AccESSORIES AccORDING
TO RIM TYPE" on this manual).
The TPMS device (optional accessory) can be used to check the proper operation
of pressure sensors.
Remove any old balancing weights from the rim.
6.3. LOADING AND cLAMPING ThE WhEEL
Loading the wheel (fig.17)
A - Place the wheel on the lift.
B - Lift the wheel by operating the pedal (1).
C - Transfer the wheel to the turntable by hand and lower the lift by operating the pedal (2).
D - When positioning the wheel on the turntable, also take care to align the mobile pin, on the
edge of the turntable, in one of the fixing bolt holes in the rim.
clamping the wheel on the turntable (fig.18)
A - Fit the clamping device into the drop centre of the wheel.
B - Turn clockwise the device for correct engagement with the turntable.
C - By hand, move the centring cone into pos. on the rim by moving the retainers 1.
D - Tighten the clamping device by turning the handles 2 clockwise.
Aquila Audax / Audax M User Manual
WARNING
NOTICE
NOTICE
16
119
Publicité
