Handlebar - Tunturi E80 Mode D'emploi

REAR AND FRONT SUPPORT
By holding on to the seat, incline the equipment
backwards so that it rests on its transportation wheels.
Attach the rear support from below with four hexagonal
socket head screws and washers. Attach the front
support to the frame with four screws and washers.
Restore the equipment to its upward position so that it
rests on the support feet.
PEDALS
The pedals are distinguished by the markings R (= right)
and L (= left) on their shafts. Fasten the right pedal to
the right pedal crank turning clockwise and the left
pedal to the left pedal crank turning counterclockwise.
Fasten the pedal bands fi rst into the retainerat the
device. Thread the band through the pedal loop and
push the band opening into the projection in the pedal.
Fasten the pedal bands to the pedal outside. Push the
band through the locking buckle and the band locks
automatically. The length of the band can be adjusted
with the locking buckle.

HANDLEBAR

Attach the cable coming from the frame tube to the
connector at the bottom of the handlebar. Ensure that
the joint is securely locked by gently pulling the wire.
Thread the wire carefully inside the frame tube. Open
the handlebar locking knob by turning it anticlockwise
a few times and then pulling it outwards. Insert the
handlebar into the front frame tube. Release the locking
knob once the handlebar has reached the required level.
Ensure that the handlebar is locked. Secure and tighten
the locking knob by turning it clockwise.
CONSOLE
Connect the cables from the handlebar to the
corresponding connectors of the console. Insert the
connected cables into the console, but make sure they
are not damaged when the console is attached. Place
the meter in position at the end of the handlebar support
tube and attach the console using 4 mounting screws.
3 ENGLISH
E80 - OWNER'S MANUAL