Handlebar - Tunturi E30 Mode D'emploi

REAR AND FRONT SUPPORT
By holding on to the seat, incline the equipment backwards
so that it rests on its transportation wheels. Attach the rear
support from below with four hexagonal socket head
screws and washers. Attach the front support to the frame
with four screws and washers. Restore the equipment to its
upward position so that it rests on the support feet.
PEDALS
The pedals are distinguished by the markings R (= right)
and L (= left) on their shafts. Fasten the right pedal to the
right pedal crank turning clockwise and the left pedal to
the left pedal crank turning counterclockwise. Fasten the
pedal bands fi rst into the retainer at the device. Thread
the band through the pedal loop and push the band
opening into the projection in the pedal. Fasten the pedal
bands to the pedal outside. Push the band through the
locking buckle and the band locks automatically. The
length of the band can be adjusted with the locking
buckle.

HANDLEBAR

Attach the cable coming from the frame tube to the
connector at the bottom of the handlebar. Ensure that
the joint is securely locked by gently pulling the wire.
Thread the wire carefully inside the frame tube and push
the handlebar support tube into place inside the frame
tube so that the fastening screws are on the front of the
tube.
NOTE! Use the enclosed Allen key to tighten both
fastening screws through the holes in the tube. Tighten the
fastening screws by turning them counter-clockwise.
CONSOLE
3 ENGLISH
E30 - OWNER'S MANUAL