Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL MODEL
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
NOTE:
Do not squeeze the priming bulb while the
engine is running, as the carburetor may over-
flow.
2. Make sure that the warm-up lever is in the
fully closed position.
3. Turn the ignition key to the "ON" position.
4. Turn the ignition key to the "START" position.
34
NOTICE
If you turn the ignition key to the
"START" position for more than 5 sec-
onds, the starter system could be dam-
aged.
Never turn the ignition key to the
"START" position for more than 5 sec-
onds.
NOTICE
If you turn the ignition key to the
"START" position while the engine is run-
ning, the starter system could be dam-
aged.
Never turn the ignition key to the
"START" position while the engine is run-
ning.
NOTE:
• If your engine does not start quickly when
warm, move the warm-up lever to the slightly
opened position and try again.
• If the engine fails to start after 5 seconds,
wait 10 seconds and try again.
5. After the engine has started, let it warm up
until the idle speed has stabilized.
NOTICE
If the Caution System is not working
properly, you may not be alerted to a con-
dition that could cause damage to your
outboard motor.
If the caution lamp does not come on
briefly once the engine starts, before
turning OFF again, the caution lamp may
be broken or a failure may exist in the
system circuit. Consult your authorized
Suzuki marine dealer.
Publicité
