Electrical Connection; Fuel Optimisation - Palazzetti ECOFIRE GIORGIA Notice D'utilisation Et D'entretien

12.8 Levelling the stove
The stove must be levelled using a spirit level and by
adjusting the feet (where included) (Fig. 5.8).
A B = Spirit Level
12.9 Connection to the systems

12.9.1 Electrical connection

Just connect the stove to the electrical system using
the plug provided.
The electrical connection (plug) must be easily
accessible even after installing the stove.
If the power cable is damaged, it must be
replaced by the technical assistance ser-
vice or by a qualified technician in order
to prevent any risk.
12.9.1.1 Earthing
The system must be earthed and fitted with a circuit
breaker in accordance with the laws in force (Fig. 5.9).
The flue gas exhaust duct must have its
own earth connection.
12.9.2 Connection to a room thermostat
It is possible to connect the stove to an external
thermostat or chronothermostat that turns the stove
on and off.
For the connection, refer to the wiring diagram in the
technical specifications.

12.10 Fuel optimisation

Excellent fuel depends on different factors (type of
installation, operating and maintenance conditions,
type of pellets, etc.)
When first switched on, the stove combustion can
be optimised.
Generally speaking, if at the end of combustion,
there is a lot of residue in the burn pot, you
should change the combustion configuration
(by increasing the value) until you find the best
solution.
Refer to the "Fuel optimisation" paragraph of the
use and maintenance manual.
004778270 - 24/07/2020
ITALIANO ENGLISH DEUTSCH FRANÇAIS
A B
ESPAÑOL
Fig. 5.8
Fig. 5.9
33