Spare Parts; Safety Warning; Warnings For The Installer; Warnings For The Maintenance Technician - Palazzetti ECOFIRE GIORGIA Notice D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour ECOFIRE GIORGIA:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

8.12 Spare Parts

Use only genuine spare parts.
Do not wait until the components are worn by use
before proceeding to their replacement.
Replace a worn component before its breaking
favours the prevention of accidents arising from
accidents caused by the sudden breakage of
components which may cause serious damages to
persons and objects.
Perform periodic maintenance checks as indicated
in the "Maintenance" chapter.
8.13 Identification plate
The serial number plate on the stove shows all the
characteristic data relating to the product, including
the manufacturer's data, the serial number and the
marking
.
8.14 Delivery of the stove
The stove is delivered perfectly packed with cardboard
or heat-shrinkable sheet and secured to a wooden
platform that allows it to be moved using forklift
trucks and/or other means.
Inside of the stove there is the following material:
instruction manual;
equipment for opening of the fire box door (only
for the relevant models).
9

SAFETY WARNING

9.1

Warnings for the installer

Observe the prescriptions contained in this manual.
The instructions for assembly and disas-
sembly of the appliance are reserved for
specialist technicians only.
It is always recommended that users contact our
after-sale service to request qualified technicians.
In the case other technicians are involved, it is
recommended to verify their actual abilities.
The responsibility of the works carried out in the area
where the stove will be installed falls, and remains,
on the user; the latter is also entrusted with the
execution of the inspections related to the installation
solutions proposed.
The user must comply with all local, national and
European safety regulations.
The appliance must be installed on floors with
adequate load bearing capacity.
004778270 - 24/07/2020
ITALIANO
ENGLISH
DEUTSCH
Verify that the chimney flue and air inlet
predispositions conform to the type of
installation.
Do not carry out flying electrical connections with
provisional or not isolated cables.
Check that the earthing of the electrical system is
efficient.
The person in charge of the installation, before
starting assembling or disassembling of the stove,
must comply with the safety precautions required
by law and in particular:
A) do not operate in adverse conditions;
B) must operate in perfect psychophysical
conditions and must check that the personal
protective equipment, are intact and functioning
perfectly;
C) must wear safety gloves;
D) must wear safety shoes;
E) must use electrical insulated tools;
F) must ensure that the area affected by the
phases of assembly and disassembly is free from
obstacles.
9.2 Warnings for the maintenance
technician
Observe the prescriptions contained
in this manual.
Always use individual safety devices
and other means of protection.
Before starting any maintenance op-
eration, make sure that the stove has
cooled down if it has been used.
If even one of the safety devices
is found to be out-of-adjustment
or not functioning, the stove should
be considered as not functioning.
Remove the power supply before
working on electrical and electronic
parts and connectors.
FRANÇAIS
ESPAÑOL
23

Publicité

Table des Matières
loading

Table des Matières