System Performance - Medtronic Envision Pro Manuel D'utilisation

Alert Description
Unable to The mobile device is unable
Connect to connect with the recorder.
Unable to The mobile device is unable
Connect
to connect with CareLink
™
CareLink software.
Unable to The mobile device is unable
Scan QR to read the QR code.
Code
Permission The app needs to access your
Required location to detect the
recorder. A location to
permission is required to
allow Bluetooth
on certain mobile devices.
Help
The app provides information on a number of topics, in both the patient and HCP
mode, with recommended steps to solve a number of common issues.
To access the Help screen, tap Help. The app will walk you through the various Help
topics.

System Performance

The performance of the Envision Pro CGM system was evaluated using this system's
zero calibration algorithm to process raw sensor data collected during a previously
conducted sensor clinical study
values provided by the Envision Pro system are accurate relative to a laboratory
reference value.
The study design was a multicenter, prospective single-sample correlational design
without controls. Each subject was instructed to wear two sensors in the abdomen
1 Medtronic Inc., A Performance Evaluation of the Enlite™ 3 Glucose Sensor to Support a Full 168
hours (7 Days) of Use, CER292DOC/F. Oct 2016. The Envision sensor is identical to the sensor
used in the clinical study except for the brand name and serial number.
Solutions
• Retry connection.
• Move the recorder closer to the Mobile
Device and retry.
• Restart the Mobile Device and retry.
If the problem persists, contact the HCP or
your local representative.
• HCP should verify CareLink
™
If not, wait until CareLink
and retry.
If the problem persists, contact the HCP or
your local representative.
• Manually enter the Clinic ID
• Go to mobile device settings and turn on
location detection for Envision
™*
to function
1
. This analysis confirmed that the sensor glucose
-17-
™
is available.
™
is available
™
Pro app.