Publicité
Scania Power Solutions engine warranty for industrial en-
gines
Emission control systems warranty for USA
IMPORTANT!
Only applicable to engines used in the U.S.A.
Table of Contents
General warranty provisions
Warranty period
Parts covered by the Warranty
General warranty limitations
Specific warranty exclusions
Customer support
Emission control system warranty statement
General warranty provisions
The emission control systems of your new Scania Engines ("Scania") industrial diesel engine were de-
signed, built and tested using genuine parts, and were certified as being in conformity with federal emission
control regulations. Scania warrants to the original owner, and to each subsequent owner, of a new Scania
industrial diesel engine ("You") that the engine:
1.
Was designed, built and equipped so as to conform at the time of sale with all applicable regulations
under Section 213 of the Clean Air Act, 42 U.S.C. § 7547, for their full useful life and designed, built
and equipped so as to conform with all applicable regulations adopted by the California Air Resources
Board pursuant to its authority under Chapters 1 and 2, Part 5, Division 26 of the California Health and
Safety Code, and;
2.
Is free from defects in material and workmanship which would cause such engine to fail to conform to
applicable regulations for its warranty period or otherwise cause the failure of a warranted part to be
identical in all material respects to the part as described in the engine manufacturer's application for cer-
tification.
Where a warrantable condition exists, Scania will repair your heavy-duty off-road engine at no cost to You
including diagnosis, parts, and labor.
Warranty period
This warranty shall apply for one of the following periods, whichever occurs first:
• 3,000 hours of operation as determined by a device to measure hours of use, or
• Five years
Each engine is equipped with a device to measure hours of use. If that device fails to account for hours of
use due to defects in materials or workmanship, the engine shall be warranted for a period of five years. The
warranty period shall begin on the date the engine is delivered to the first ultimate purchaser who, in good
OPM 100 fr-FR
Scania Power Solutions engine warranty for industrial engines
4
4
5
6
7
7
5
©
Scania CV AB 2023, Sweden
Publicité
