Publicité
Les langues disponibles
Les langues disponibles
TECHNICAL SPECIFICATIONS
Rated power supply
Max Electrical power absorbed
Light source
Times that may be set
Acoustic signals
Classification:
Wavelength
Rated lighting intensity
Applicable standards
The manufacturer promises to provide, upon request, wiring diagrams, component parts lists, calibration instructions or
other information that may be needed by authorised technical service personnel.
The manufacturer reserves the right to bring about modifications at any moment without notice.
SYMBOLS
Symbol to call the attention to other information found in the equipment User Manual.
Symbol corresponding to "TYPE B PART APPLIED" according to IEC 60601-1.
Indicates a protection grade against direct and indirect contacts
Part that may be sterilised in an autoclave
Symbol for disposal pursuant to the 2002/95/EC, 2002/96/EC, 2003/108/EC Directives.
CONNECTION TO THE POWER SUPPLY CABLE
The LEDA curing lamp must be coupled completely into its own electrically powered hose by simple pressure. It is
necessary to make sure that the coupling surfaces are clean and dry.
All manuals and user guides at all-guides.com
"LEDA" CURING LIGHT
LEDA
32 V DC
10.5 W
1 5 W LED
20 – 40 – 60 s
Upon turn-on, every 5 seconds and upon shut down
Class IIa (Directive 93/42 CEE)
Class II type B (IEC 60601-1)
λ 440 ÷ 480 nm
1000 mW/cm²
IEC 60601-1 – IEC 60601-2 - ISO 10993-1
IEC 60825-1:1993 + A1:1997 + A2:2001
CONNECTION OF OPTICAL FIBRE
The optical fibre can be rotated 360° and must always be
properly inserted to avoid output loss.
31/01/2011 - 97050183-03-GB - 72
Publicité
