Publicité
Les langues disponibles
Les langues disponibles
§ After unpacking the equipment,
$ If damage is evident, refer to the
$ It is a good idea to save the box
$ Before packing your equipment,
– Complete scale (weighing platform
– Installation Instructions and Safety
– Operating instructions (incl. approvals
§ Observe all safety instructions.
°C
– Set up the EC1XS.-......-L on a stable,
– Avoid placing the equipment in close
– protect the EC1XS.-......-L from direct
– Avoid exposing the EC1XS.-......-L
6
Installation Instructions
Unpacking the Equipment
please check it immediately for any
visible damage. Please read the
enclosed operating instructions care-
fully before putting the equipment
into operation.
instructions under "Safety
Inspection" in the chapter entitled
"Care and Maintenance."
and all parts of the packaging until
you have successfully installed
your equipment. Only the original
packaging provides the best pro-
tection for shipment.
unplug all connected cables to
prevent damage.
Equipment Supplied
and display and control unit)
Information (incl. Documents for
Hazardous Areas)
for optional equipment)
An external power supply is necessary
for operation of the scale:
YPS05-XD (hazardous area)
YPS05-ZD (non-hazardous area)
Note:
No power supply is included with
the equipment.
Requirements on the Place of
Installation
The EC1XS.-......-L is designed to
provide reliable results under normal
ambient conditions.
When choosing a location to set
up the EC1XS.-......-LX, observe the
following so that you will be able to
work with added speed and accuracy:
even surface. The carrying capacity of
the chosen working surface must be
sufficient for both the weighing plat-
form and any load placed on it.
proximity to a heater or otherwise
exposing it to heat or direct sunlight.
exposure to drafts that come from
open windows or doors.
to excessive vibration.
– Protect the EC1XS.-......-L from
aggressive chemical vapors.
– Do not expose the equipment
to excessive electromagnetic inter-
ference, as it can affect the value
displayed.
– Turn off the power when the system
is not in use
– The allowable operating
temperature range is –10°C to +40°C
(14°F to 104°F)
§ Level the weighing platform using
the leveling feet as described below:
§ Check to ensure that all leveling feet
rest securely on the work surface.
> Each of the leveling feet must
support an equal load.
§ Loosen the locknuts on the leveling
feet using a 19-mm open-end
wrench (spanner).
> Adjusting the leveling feet:
To raise the weighing platform,
extend the leveling feet
(turn clockwise).
To lower the weighing platform,
retract the leveling feet
(turn counterclockwise).
§ After leveling the weighing platform,
tighten the lock nuts as follows:
Low-capacity platforms (1 load cell):
tighten the locknuts against the plat-
form frame. High-capacity platforms
(4 load cells): tighten the locknuts
against the platform feet.
§ If the scale is in a hazardous area,
it must be grounded (i.e., an equi-
potential bonding conductor must
be connected; resistance: <1 ohm).
This connection should be made by
a trained technician (see "Warnings
and Safety Precautions").
Minebea Intec power supplies are equipped
!
with fuses for protection from over-
heating. The fuse responds when the
temperature exceeds 40°C (104°F).
Make sure power supplies have ade-
quate cooling/ventilation. You can
use screws to affix the power supply
to a metal plate if necessary. Prevent
build-up of excessive heat.
Publicité
