Publicité
Les langues disponibles
Les langues disponibles
GENERAL SAFETY RULES
KEEP HANDS AWAY FROM CUTTING AREA. Keep
hands away from wheels. Do not reach underneath work
or around or over the wheel while wheel is rotating. Do not
attempt to remove cut material when wheel is moving.
WHEEL COASTS AFTER BEING TURNED OFF.
NEVER USE IN AN EXPLOSIVE ATMOSPHERE.
Normal sparking of the motor could ignite fumes.
INSPECT TOOL CORDS PERIODICALLY. If damaged,
have repaired by a qualified service technician at
an authorized service facility. The conductor with insulation
having an outer surface that is green with or without yellow
stripes is the equipment-grounding conductor. If repair
or replacement of the electric cord or plug is necessary,
do not connect the equipment-grounding conductor to a
live terminal. Repair or replace a damaged or worn cord
immediately. Stay constantly aware of cord location and
keep it well away from the rotating wheel.
INSPECT EXTENSION CORDS PERIODICALLY and
replace if damaged.
GROUND ALL TOOLS. If tool is equipped with three-
prong plug, it should be plugged into a three-hole electrical
receptacle.
ONLY POWER THE TOOL WITH A GFCI (GROUND
FAULT CIRCUIT INTERRUPTOR) PROTECTED OUT-
LET.
CHECK WITH A QUALIFIED ELECTRICIAN or service
personnel if the grounding instructions are not completely
understood or if in doubt as to whether the tool is properly
grounded.
USE ONLY CORRECT ELECTRICAL DEVICES: 3-wire
extension cords that have 3-prong grounding plugs and
3-pole receptacles that accept the tool's plug.
DO NOT MODIFY the plug provided. If it will not fit the
outlet, have the proper outlet installed by a qualified
electrician.
All manuals and user guides at all-guides.com
KEEP TOOL DRY, CLEAN, AND FREE FROM OIL AND
STAY ALERT AND EXERCISE CONTROL. Watch what
DO NOT USE TOOL IF SWITCH DOES NOT TURN IT
USE ONLY CORRECT WHEELS. Do not use wheels with
BEFORE MAKING A CUT, BE SURE ALL ADJUST-
NEVER TOUCH WHEEL or other moving parts during
NEVER START A TOOL WHEN ANY ROTATING COM-
DO NOT OPERATE A TOOL WHILE UNDER THE
WHEN SERVICING use only identical replacement parts.
USE ONLY RECOMMENDED ACCESSORIES listed in
DOUBLE CHECK ALL SETUPS. Make sure wheel is tight
4 — English
GREASE. Always use a clean cloth when cleaning. Never
use brake fluids, gasoline, petroleum-based products, or
any solvents to clean tool.
you are doing and use common sense. Do not operate
tool when you are tired. Do not rush.
ON AND OFF. Have defective switches replaced by an
authorized service center.
incorrect size holes. Never use washers or arbor nuts that
are defective or incorrect. The maximum wheel capacity
of your saw is 10 in. (254 mm).
MENTS ARE SECURE.
use.
PONENT IS IN CONTACT WITH THE WORKPIECE.
INFLUENCE OF DRUGS, ALCOHOL, OR ANY
MEDICATION.
Use of any other parts may create a hazard or cause
product damage.
this manual or addendums. Use of accessories that are
not listed may cause the risk of personal injury. Instruc-
tions for safe use of accessories are included with the
accessory.
and not making contact with saw or workpiece before
connecting to power supply.
Publicité
