RIDGID R4040 Manuel D'utilisation

To register your RIDGID product,
please visit: http://register.RIDGID.com
WARNING:
To reduce the risk of injury, do not attempt to use
this product until you have read thoroughly and
understand completely this Operator's Manual and
the Operator's Manual for your tile saw.
UNPACKING
This product has been shipped completely assembled.
n Carefully remove the product from the box. Make sure
that all items listed in the packing list are included.
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing
or damaged. Use of a product that is not properly
and completely assembled could result in serious
personal injury.
n Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
n Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
n If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this tool until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
OPERATOR'S MANUAL
TILE SAW STAND
FOR USE ONLY WITH THE RIDGID R4040 TILE SAW
SAVE THESE INSTRUCTIONS
PACKING LIST
See Figure 1.
Stand, Height Adjustment Pin (4), and Operator's Manual
SETTING UP THE STAND
See Figures 2 - 5.
n With the unit in the upright position, spread the legs of
the stand. Place stand on level ground.
NOTE: When positioning the stand make sure each leg
is spread fully outward to ensure the stand's stability.
n To adjust the height of the stand, move each adjustable
foot up or down until the hole in the leg is aligned with
one of the holes in the foot. Secure the feet in place using
height adjustment pins with bales.
NOTE: Make sure the feet are positioned at the same
height to ensure stability.
n Line up channels under tile saw with braces on stand.
Position saw onto stand. Make sure that the tile saw is
flush against the stand and that all the stand legs are
touching the ground.
n Make sure the stand is stable and on level ground before
using the tile saw.
ONE WORLD TECHNOLOGIES, INC.
P.O. Box 1427, Anderson, SC 29622
1-866-539-1710 / www.ridgid.com
English
990000487
7-9-18 (REV:02)