Steba DG 40 Mode D'emploi page 25

∙ Before initial use: clean all parts carefully and leave to dry.
Heat up the device for about 15 min. to eliminate the smell of
newness.
∙ Attention! Device gets hot. Danger of burns! Touch-
able surfaces will be hot during operation! Place the
device on a flat and insensitive surface with and keep a
distance of at least 70cm to burnable materials.
∙ During operation steam emerge. Keep hands and face away.
∙ If an extension cable is used, it has to have a cross-section of
1,5mm²
∙ If a GS-tested 16 A multi-pin extension is used, it may not be
charged with more than 3680 watts due to fire hazard.
∙ Make sure that children do not tease the cable or that a trip
hazard occurs.
∙ The device must always be disconnected from the power supply
if it is not supervised and before assembling, disassembling or
cleaning.
∙ Attention: as dripping fats can easily ignite the radiator, never
grill without a pan! When removing the full pan, do not tip any
grease on the radiator.
∙ Please use the enclosed handle to remove the wire grill and
baking tray.
∙ Hygiene: Please always clean the device to avoid bacteria and
mould formation.
Cleaning
∙ Attention! Pull the plug before cleaning and allow
the device to cool down.
∙ Never immerse the unit into water.
∙ Fat residues must be removed for reasons of hygiene and fire
hazard.
∙ Remove soiling immediately after each use. The longer the re-
main in the device, the worse they can be removed.
∙ Do not use abrasives, oven spray or solvents.
25