HOLZMANN MASCHINEN HOB310ECO 230V Mode D'emploi page 45

TROUBLESHOOTING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
Many possible sources of error can be excluded in advance if the machine is properly connected to
the Disconnect the machine from the power supply. If you are unable to carry out necessary
repairs properly and/or do not have the required training, always consult a specialist to correct the
problem.
Problem
Machine does not start or
shuts down automatically
during idling
Machine stops during
operation
Machine vibrates during
operation
Workpiece clamps during
thicknessing
Bad surface condition
after operating
Rough surface after
operating
Cracked surface after
operating
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WAR N I N G
Possible cause
 Power supply outage
 Damaged or incorrect connected
extension cable
 Damaged switch or motor
 Blunt blade
 Feeding speed to high
 Motor protection triggered
 Wrong adjusted blade
 Ground not flat or base feet
wrong adjusted
 Cutting depth to high
 Dirty thicknessing table
 Blunt blade
 Uneven feed of the workpiece
 Workpiece too moist
 Workpiece was processed against
the direction of growth
 Cutting depth to high
TROUBLESHOOTING
Solution
Check fuse of the power

supply
Check plug or extension

cable
Contact customer support

Check blade

Work with lower feeding

speed
Let the motor cool down

Check the setting of the

blades
Set the base feet correct

Set the correct cutting

depth and operate in
more steps
Clean and apply the table

surface with lubricant
Check blade

Feed workpiece evenly

and with constant
pressure
Use drier workpiece

Proceed the workpiece in

opposite direction
Set the correct cutting

depth and operate in
more steps
HOB310ECO_230V | HOB310ECO_400V
45