HOLZMANN MASCHINEN HOB310ECO 230V Mode D'emploi page 42

CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
18.1 Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
• Remove chips and dirt particles from the machine after each use with a proper tool.
• Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
18.2 Maintenance
The machine is low maintenance and only a few parts require maintenance. Malfunctions or
defects that are likely to impair your safety must be rectified immediately!
• Check that the safety devices are in good condition before each operation.
• Check the connections at least once a week for a tight fit.
• Check the correct and readable status of the Machine's warning and safety labels on a
regular basis.
18.2.1 Maintenanceplan
Wear of machine depends strongly on operation condition. The following intervals are valid when
using the machine within the operation limits
Interval Componente
Anti-kick-back device
Before every
usage
Machine
V-Belt
monthly Feed/Pull-out roller
Height adjustment
Chain-drive (feed)
Half yearly
Gear (feed)
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
WAR N I N G
N O TE
Activity
At least once per work-shift by inspection to verify that they are
in good working condition, eg have no impact damages to the
surface and that the anti-kick back device fall back freely due to
its own weight after lifting.
Cleaning (from dust and chips)
Check retighten or replace if necessary.
Check and clean thoroughly
Control, lubrication
Check for damage/wear, lubricate, replace if necessary
Check for damage/wear and replace if necessary.
HOB310ECO_230V | HOB310ECO_400V
42