Publicité
Les langues disponibles
Les langues disponibles
For readjusting to planer mode please lower the thicknesser table at least to lowest
position to avoid any damages.
16.7.2
Thicknessing of workpieces
working direction
•
In the case of resin residues on the wood, it may be advisable to apply a thin
layer of a special lubricant to the machine table in order to ensure that the
workpiece slides evenly through the thickness planer.
•
If the workpiece is no longer moved by the automatic feed, pull out the
workpiece manually.
•
After operation switch off the machine and set the lever for thicknesser feeder
to position "OFF".
•
Before further activities wait until blade shaft is at a standstill!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Proceed in reverse order to readjust to the planer
mode.
N O TE
• Unlock the locking lever height adjustment thicknesser (1)
and set the required height of the thicknessing table with
the handwheel (2).
• The height will be shown on the indicator (3).
• Set the thicknessing table height to the workpiece height
minus the requested cutting depth.
• Maximum cutting depth refer to the technical data!
NOTE:
At the beginning of the thicknessing process, the
workpieces may still have very different thicknesses - this
must be taken into account in the set cutting depth in order
not to overload the machine.
• Fix the thicknessing table height with the locking lever
height adjustment.
• Switch on the machine.
• Put the lever for thicknesser feeder (4) to the upper
position to start the feed.
• Insert workpiece so that the surface to be machined facing
upwards and push forward
• The workpiece is pulled through of the automatic feed
• As soon as the half of the workpiece has been processed change to
the opposite operator side of the machine and take on the finished
workpiece.
• After operation switch off the machine.
• Before further activities wait until blade shaft is at a standstill!
N O TE
OPERATION
HOB310ECO_230V | HOB310ECO_400V
40
Publicité
