Publicité
Les langues disponibles
Les langues disponibles
NOTE:
To transport the machine, you need a forklift truck with the appropriate load capacity and a
fork of at least 1200 mm length. The fork of the truck should be positioned under the machine.
NOTE:
Do not transport the machine at the work tables, these are not designed to withstand the
tensile load of the machine weight.
ASSEMBLY
15.1
Check scope of delivery
Always note visible transport damages on the delivery note and check the machine immediately
after unpacking for transport damage or missing or damaged parts. Report any damage to the
machine or missing parts immediately to your retailer or freight forwarder.
15.2
Requirements for the place of installation
Choose a suitable place for the machine. Pay attention to the safety requirements and the
dimensions of the machine. The selected location must ensure a suitable connection to the power
supply as well as the possibility of connection to an extraction system. Make sure that the floor can
support the load of the machine. The machine must be levelled simultaneously at all support
points. It is also necessary to guarantee a distance of at least 0.8 m around the machine. In front of
and behind the machine, the necessary distance must be provided for the feeding of long
workpieces.
15.3
Preparation of the surface
The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners will result
in damage to the surface! Therefore use only mild cleaning agents.
Before you install and commission the machine at the intended location, carefully remove the
anti-corrosion protection and grease residues. This can be done with the usual solvents. Under no
circumstances should you use nitro thinner or other cleaning agents that could attack the
machine's paint.
15.4
Assembling the machine
The machine is pre-assembled. The parts that have been disassembled for transport must be
assembled before use. Follow the instructions below:
The machine and machine components are heavy!
2 persons are required to assemble the machine.
Handling the machine with the power supply intact can result in serious injury or
death. Therefore, do not connect the machine to the power supply before
completing the assembly.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O TE
N O TE
WAR N I N G
ASSEMBLY
HOB310ECO_230V | HOB310ECO_400V
33
Publicité
