Publicité
Les langues disponibles
Les langues disponibles
•
Do not remove any sections or other parts of the workpiece from the cutting area while the
machine is running!
•
Always work with care and the necessary caution and never use excessive force.
•
Do not overload the machine!
•
Do not work on the machine if it is tired, not concentrated or under the influence of
medication, alcohol or drugs!
•
Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
•
Do not smoke in the immediate vicinity of the machine (fire hazard)!
•
Make sure that the main switch is in the "O" position before connecting the machine to the
power source.
•
Ensure that the machine is earthed.
•
Only use suitable extension cords.
•
Always shut down the machine before carrying out any conversion, adjustment, measuring,
cleaning, maintenance or repair work and always disconnect it from the power supply for
maintenance or repair work. Before starting work on the machine, wait until all tools or
machine parts have come to a complete standstill and secure the machine against
unintentional restarting.
13.5
Electrical safety
•
Make sure that the machine is earthed.
•
Only use suitable extension cords.
•
A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
Never use the cable to carry, pull or disconnect the machine. Keep the cable away from
heat, oil, sharp edges or moving parts.
•
Proper plugs and sockets reduce the risk of electric shock.
•
Water that enters the machine increases the risk of electric shock. Do not expose the
machine to rain or moisture.
•
The machine may only be used in humid environments if the supply is protected by a
residual current circuit breaker.
•
Do not use the machine if it cannot be turned on and off with the ON/OFF switch.
13.6
Special safety instructions for that machine
•
Work with gloves on rotating parts is not permitted!
•
Wood dust is generated when the machine is in operation. Therefore, connect the machine
to a suitable extraction system for dust and chips during installation!
•
Always switch on the dust extraction device before you start machining the workpiece!
•
Never remove chips or other parts of the workpiece from the cutting area while the
machine is running.
•
When using milling tools with a diameter of ≥ 16 mm and circular saw blades, these must
comply with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-3:2013;
•
Excessive noise can cause hearing damage and temporary or permanent hearing loss.
Wear hearing protection certified to health and safety regulations to limit noise exposure.
•
Only use blades that are suitable for that machine.
•
For handling short and narrow workpieces use sliding wood.
13.7
Hazard warnings
Despite its intended use, certain residual risks remain:
•
Risk of injury to fingers and hands from the rotating blades if the workpiece is guided
improperly.
•
Injuries caused by the workpiece being thrown away by improper mounting or guidance, such
as working without a stop.
•
Danger to health from wood dust or chips. It is essential to wear personal protective
equipment such as eye protection and a dust mask. Use a dust collection system!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
SAFETY
HOB310ECO_230V | HOB310ECO_400V
31
Publicité
