HOLZMANN MASCHINEN HOB310ECO 230V Mode D'emploi page 37

The alignment of the planer fence at right angles should be checked again
before initial operation and readjusted if necessary to achieve an exact
planing result.
16.4 Handling
16.4.1 Switch the machine on and off
Switch on
Push green ON-button (I)
Switch off
Push red OFF-button (0)
16.4.2 Activating/Deactivating the thicknesser feed rate
16.5 Dust collection plug
Do not operate the machine without the dust collection system connected to it and switched on.
The dimensions of the dust collection plug can be found in the technical data.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• The angle is measured with a protractor (8). This is placed on the planer
table and applied to the planer fence.
• If it is not possible to place the protractor completely against the planer
fence, the planer fence is not set exactly at right angles and an
adjustment of the scale (10) is necessary.
Activate feed:
Swivel the lever for thicknesser feeder (1) upwards.
Feed is activated
Deactivated feed:
Swivel the lever for thicknesser feeder (1)
downwards. Feed is deactivated.
Planer:
The extraction connection (1) is under the planer
tables (exit planer table)
Thicknesser:
After the conversion to thicknessing, fold down the
dust colletor hood (2).
OPERATION
HOB310ECO_230V | HOB310ECO_400V
37