Publicité
Les langues disponibles
Les langues disponibles
16.8
After working process
After the working process the planer and thicknesser must be turned off:
•
Switch off the machine and disconnect the machine from the power supply.
•
After operation set the lever for thicknesser feeder to position "OFF".
Adjust the planer knife cover so that the planer shaft is completely covered
•
OPERATION MORTISING UNIT (OPTIONAL)
NOTE:
Operation of the mortising unit only after converting to thicknessing mode
• Assembly see HOB310ECOLL
• Clamp the milling tool required for drill chuck (1) of the planning shaft
• Lay up the workpiece on the mortising table (2)
• Tilt the downholder (3) to the middle of the workpiece
• Push the clamping lever of the downholder to clamp the workpiece
• Loosen the locking lever (4) and adjust the table height with the crank handle (5) to the
requested height of the milling tool
• Adjust the horizontal travel of the table with both longitudinal stops (6)
• Start the machine (see operation planer and thicknesser)
• Move the table with the operating lever (7) in left direction to the limiter
• Press down the workpiece carefully on the milling tool and up to penetration depth of milling
(depending the depth stop)
• Move the operating lever carefully to the right direction to the stop
• Repeat this process until the requested milling result has been reached
• Move the lever backwards to release the milling tool out of the workpiece
• After the working process switch of the machine (see operation planer and thicknesser)
• Before further activities wait until planning shaft is at a standstill!
17.1
After working process
After the working process the planer and thicknesser must be turned off:
•
Switch off the machine and disconnect the machine from the power supply.
Dismount the milling tool.
•
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION MORTISING UNIT (OPTIONAL)
N O TE
Step 1:
Step 2:
Step 3:
N O TE
HOB310ECO_230V | HOB310ECO_400V
41
Publicité
