Diamond FVS-423 Manuel D'instructions page 8

4.5 SETTING OF COOKING PARAMETERS
4.5A COOKING CHAMBER TEMPERATURE
Pressing the button shown on the side you activate modification of cooking chamber tem-
perature.
The led above the button flashes and the display shows the set temperature for the cooking
chamber.
Pressing the button shown on the side, the value shown by the display increases.
Pressing the button shown on the side, the value shown by the display decreases.
NOTE: if you keep one of the buttons with the arrow pressed, after 2 seconds the value shown on the
display will change of 10 to 10.
When the display shows the established value, possible actions are the following:
• Press the temperature button again, in this way the led stops to flash and the new value is stored
when the oven will start cooking.
• Press directly the start button. In this case the oven will have the value visualized on the display
before pressing start.
• Press another button (ex.time, core probe, humidification) to set a new parameter.
NOTE: while the led is flashing, if you don't press any further button, after 10 seconds the oven will
store the value visualized by the display and the led will stop flashing.
The cooking chamber temperature set is the following:
• Convection mode with humidification adjustment (or combination) 20 - 270 °C
• Steam mode 20 - 100 °C
7
EN