Diamond FVS-423 Manuel D'instructions page 16

6.0 AUTOMATIC WASHING SYSTEM
In the ovens with automatic washing system, pressing the button shown on the side, the
displays visualize CLE PrG (Cleaning program).
To activate this function it's necessary to stop the oven.
VERY IMPORTANT: the automatic washing system device is an optional, that can be installed only
upon order of the oven.
After you have activated the function, pressing start button you activate the washing cycle.
NOTE: After you have pressed start, you cannot interrupt the washing cycle.
If you press start and the cooking chamber temperature is over 90°C, the displays visualize OPn dor
(open door). Opening the door you activate the cooling that stops when the temperature drops below
90°C. At the end of cooling cycle, the displays visualize the message CLS dor (close door), closing the
door the washing cycle starts.
During the automatic washing cycle, the above display shows the temperature inside the cooking cham-
ber and the below display shows the time missing to end the washing cycle.
In models equipped with automatic washing with liquid detergent, in
the back side of the ovens supplied with automatic washing system,
there are 2 small pipes for the suction of detergent and sparkling-aid.
The red color pipe must be inserted into the liquid detergent container.
The white color pipe must be inserted into the liquid sparkling-aid con-
tainer.
IMPORTANT NOTE: ensure that the liquid detergent and sparkling-aid
are specific for stainless steel cleaning.
Check frequently the level of the detergent and sparkling-aid inside
their containers, in order to avoid any damage to the pump if it works
in vain.
NOTE: to facilitate the dissolution of dirt, we advise to spray the internal part of the
cooking chamber with a degreasing product suitable for oven cleaning.
15
EN