Publicité
Les langues disponibles
Les langues disponibles
Step mode control function selection (PP)
Open-stop-close-stop-open-stop-close...
The automatic closing timer restarts if a new step mode command is received with the boom in the
completely open position. Step mode commands are ignored while the barrier is opening. This allows the
boom to open completely and prevents unintentional closing.
If automatic closing is disabled (
manoeuvre
The automatic closing timer does NOT restart if a new step mode command is received.
Step mode commands are ignored while the barrier is opening. This allows the boom to open completely
and prevents unintentional closing.
If automatic closing is disabled (
manoeuvre
Open-close-open-close.
Open-close-stop-open.
Flashing warning signal for 1 to 10 seconds prior to every manoeuvre.
Condominium function for partial open command (PED)
Enabled. Partial open commands (PED) are ignored during barrier opening.
Enable "operator present" function
N.B.: this parameter is not visible if the value of parameter
Disabled.
Enabled. The open (AP) or close (CH) button must be pressed continuously to operate the barrier. The
boom stops when the button is released.
Barrier open/photocell test function and battery saving mode indicator lamp
N.B.:
the parameter
is other than
The indicator is off when the barrier is closed, and steadily lit during manoeuvres and when the barrier
is open.
open. Flashing rapidly during closing manoeuvres.
If the barrier is stopped in an intermediate position, the lamp extinguishes twice every 15 s.
Set to
if the output SC
Set to
if the output SC
When the barrier is completely open or closed, the controller unit deactivates any accessories connected
to terminal SC to reduce battery consumption.
N.B.: setting not available for installations with two opposing barriers. This value is not visible if the value
of parameter
=
,
,
Set to
if the output SC
N.B.: setting not available for installations with two opposing barriers. This value is not visible if the value
of parameter
=
,
Enable the B73/EXP signal device to indicate barrier completely open/closed po-
sitions (NC potential free contact)
Disabled.
Enabled.
When the boom is completely open, contact TO (NC) opens and the green LED illuminates on the B73/EXP board.
When the boom is completely closed, contact TC (NC) opens and the red LED illuminates on the B73/EXP board.
Setting deceleration during opening
), the condominium function automatically attempts a closing
), the condominium function automatically attempts a closing
.
or
=
,
.
or
or
=
,
.
=
,
or
.
) or if
83
Publicité
