Roger Technology CTRL Instructions Et Consignes Pour L'installateur page 75

11
Travel acquisition
For the system to function correctly, the barrier travel must be acquired by the controller.
11.1
Before starting:
IMPORTANT: Select the length of the boom with the parameter
It is very important that this parameter is selected correctly. An incorrect setting may cause severe damage
or injury.
SELECTION
1. Select the position of the barrier in relation to the gate, using parameter
with the barrier installed on the right (
hatch side).
If the installation position is changed from the right to the left, the position of the spring(s) must also be
changed.
For the correct installation, refer to the barrier installation manual.
AG/004
KB/004
BI/004HP
AG/004
KB/004
BI/004HP
AG/006
KB/006
BI/006
BI/004
BI/004
BI/008
) and the boom opening/closure gate on the left (seen from the inspection
MODEL
. The factory setting of the parameter is
IMPOSTAZIONE DI FABBRICA
FACTORY SETTING
.
BOOM
up to 3 m
from 3 m
to 4,5 m
from 4,5
to 6 m
up to 3 m
from 3 m to 4 m
up to 8 m
75