Roger Technology CTRL Instructions Et Consignes Pour L'installateur page 78

If the installation position is changed from the right to the left, the position of the spring(s) must also be
changed.
6. MASTER
45°
PROG
AP P-
x4 s
AU to
OPENING
• Press and hold PROG for 4 seconds.
• Unlock the barrier.
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key anticlockwise by two full turns.
BIONIK4. Open the release cover.
• The barrier goes to 45° degree.
• After a few seconds, the message
The operating parameters of the motor are determined during calibration.
• If the motor calibration procedure is successful, the message
• To lock the barrier again
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key clockwise by two full turns.
BIONIK4. Close the release cover and turn the key.
• The acquisition procedure now starts. The message
at low speed.
•
• The barrier closes until it reaches the barrier closed mechanical stop.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display mode.
•
• .
For more information, see chapter 16 "Alarms and faults".
7. SLAVE
45°
PROG
AP P-
x4 s
AU to
OPENING
• Press and hold PROG for 4 seconds.
• Unlock the barrier.
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key anticlockwise by two full turns.
BIONIK4. Open the release cover.
• The barrier goes to 45° degree.
• After a few seconds, the message
The operating parameters of the motor are determined during calibration.
78
UNLOCK
2x360°
BIONIK 4HP, 6,
8, PC, PE ONLY FOR BI/004
AU AU to to
OPEN
wait...
is shown on the display.
is shown on the display. The controller unit launches a calibration procedure.
UNLOCK
2x360°
BIONIK 4HP, 6,
8, PC, PE ONLY FOR BI/004
AU to AU to
OPEN
wait...
is shown on the display.
is shown on the display. The controller unit launches a calibration procedure.
PH A5 PH A5 PH A5
wait...
CLOSING CLOSED
is shown on the display and the barrier starts opening
PH A5 PH A5 PH A5
wait...
CLOSING CLOSED
LOCK
2x360°
BIONIK 4HP, 6,
8, PC, PE ONLY FOR BI/004
Yes
LOCK
2x360°
BIONIK 4HP, 6,
ONLY FOR BI/004
8, PC, PE
Yes