Roger Technology CTRL Instructions Et Consignes Pour L'installateur page 73

8
Function buttons and display
UP
DOWN
PROG
• Press the UP and/or DOWN
• Use the + and -
• Press and hold the + or - button to scroll quickly through values, to modify the parameter more quickly.
• To save the new value, wait a few seconds or move onto another parameter with the UP
•
9
Switching on or commissioning
Power the control unit.
Version installed P4.10.
Immediately afterwards, the displays enters the commands and safety device status mode. See chapter 10.
For installations with two opposing barriers, settings must be made from the MASTER controller. Only the parameters
and
10
Display function modes
10.1
Parameter display mode
PARAMETER
PARAMETER
See chapter 12 for detailed descriptions of parameters.
TEST
buttons to view the parameter you intend to modify.
VALUE
BUTTON DESCRIPTION
Next parameter
UP
DOWN Previous parameter
+ Increase value of parameter by 1
- Decrease value of parameter by 1
PROG Travel acquisition
TEST Activate TEST mode
or DOWN button. The
73