Roger Technology CTRL Instructions Et Consignes Pour L'installateur page 77

• Unlock the barrier.
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key anticlockwise by two full turns.
BIONIK4. Open the release cover.
• The barrier goes to 45° degree.
• After a few seconds, the message
The operating parameters of the motor are determined during calibration.
• If the motor calibration procedure is successful, the message
• To lock the barrier again
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key clockwise by two full turns.
BIONIK4. Close the release cover and turn the key.
• The acquisition procedure now starts. The message
at low speed.
•
• The barrier closes until it reaches the barrier closed mechanical stop.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display mode.
•
• .
For more information, see chapter 16 "Alarms and faults".
11.3
MASTER/SLAVE acquisition procedure:
1. Check the spring balance setting and the mechanical stop settings.
For further information, refer to the installation manual of the barrier.
2. With both control units not powered (and with battery disconnected, if present), make the bus connections on the
COM
+SC
+LUCI
COM
+24V
+ES
+LAM
COM
COM
LNA
LNB
3. Enable RS485 serial communication (MASTER)
4. Enable RS485 serial communication (SLAVE)
5. Select the position of the barrier in relation to the gate, using parameter
with the barrier installed on the right (
hatch side). The position of the SLAVE barrier is automatically set to complementary.
is shown on the display. The controller unit launches a calibration procedure.
>45°
45°
SLAVE
) and the boom opening/closure gate on the left (seen from the inspection
is shown on the display and the barrier starts opening
<45°
COM
MASTER
+SC
+LUCI
COM
+24V
+ES
+LAM
COM
COM
LNA
LNB
. The factory setting of the parameter is
IMPOSTAZIONE DI FABBRICA
FACTORY SETTING
77