Getting Started; Assembly - Evolution FURY3-XL Instructions D'origine

All manuals and user guides at all-guides.com
Fig 1
Fig 2
Fig 3

GETTING STARTED

ASSEMBLY

CAUTION! ALWAYS DISCONNECT THE SAW FROM THE
POWER SOURCE BEFORE MAKING ANY ADJUSTMENTS.
Refer to the "Service Parts List Drawing". Install a blade as
detailed in the "Installing or Removing the Blade" section.
1. Mounting the Mitre Saw
WARNING: To reduce the risk of injury from unexpected
saw movement, place the saw in the desired location either
on a workbench or other recommended leg set. The base
of the saw has four holes to mount the mitre saw. If the
saw is to be used in one location, permanently fasten it to
the workbench or leg set using appropriate bolts with lock
washers and nuts.
1. Tighten the slide, mitre and bevel locks.
2. Position the saw so other people cannot stand behind it.
Thrown debris could injure people in its path.
3. Place the saw on a firm, level surface where there is plenty
of room for handling and properly supporting the workpiece.
4. Support the saw so that the table is level and the saw
does not rock.
5. Bolt or clamp the saw to its support.
2. Installing or removing the blade
WARNING! Only use genuine Evolution blades which are
designed for this machine. Ensure that the maximum speed
of the blade is compatible with the machine. Only carry
out this operation with the machine disconnected from the
mains supply.
NOTE: It is recommended that the operator considers
wearing protective gloves when handling the blade during
installation or when changing the machines blade.
1. Ensure the cutting head is up.
2. Remove the guard operating arm retaining clip (Fig. 1).
Release the guard operating arm from its pivot.
3. Press the lower blade guard locking trigger and lift up the
lower blade guard. (Fig. 2)
4. Press the black arbor lock button to lock the arbor. (Fig. 3)
5. Using the supplied Allen Key, release the arbor screw to
remove the blade. (Fig. 4)
Note: The arbor screw has a LH thread.
www.evolutionfury.com
GB
11