Evolution FURY3-XL Instructions D'origine page 16

Fig 8
Fig 9
Fig 10
16
All manuals and user guides at all-guides.com
®
6. Mitre Cut (Fig. 8)
An angle of up to 45
Positive stops are provided at 15
and left.
1. Loosen the slide locking knob, and push the cutting head
back as far as it will go and lock the slide.
2. Loosen the mitre angle lock knob.
3. Pull up the positive stop locking lever.
4. Turn the rotary table to the desired angle as indicated by
the mitre angle pointer.
5. Tighten the mitre angle lock knob to hold the desired angle.
6. If necessary unlock the cutting head by loosening the
slide locking knob. This will allow the cutting head to move
backwards and forwards (required when cutting wide boards).
7. Start the saw and allow it to reach full speed before
commencing operations.
7. Bevel Cut Left (Fig. 9)
1. Lock the cutting head down with the head latching pin.
2. Loosen the bevel lock lever.
3. Tilt the cutting head to the required angle. A protractor
scale and pointer is provided to aid setting. This is found just
behind the bevel lock lever.
4. Tighten the bevel lock.
5. Unlatch the cutting head.
6. Release the slide (if necessary) to cut wide workpieces.
7. Stand to the left side of the handle to make the cut
8. Compound Cut
A compound cut is a combination of a mitre and bevel cut.
When a compound cut is required, select the desired bevel
and mitre positions as previously explained.
9. Depth Stop (Fig.10)
Use of the depth stop allows the operator to cut slots in the
workpiece. The downward travel of the saw head can be set
so that the saw blade does not completely cut through the
workpiece.
Note: It is advisable that the depth of cut is checked using a
scrap piece of timber to ensure that the slot cut is correct.
By making a cut in the workpiece, and then repeating the
cut but with the workpiece slightly repositioned to the left or
right, it is possible to perform trenching cuts.
To use the depth stop:
1. Loosen the locking wing nut.
2. Adjust the thumb knob to limit the saw heads travel to the
required depth.
3. Once set to the desired depth, tighten the wing nut
against the retaining bracket to lock the depth stop and
www.evolutionfury.com
to the left or right can be obtained.
0
, 22.5 , 30
0 0 0
and 45 right
0