Operation - Evolution FURY3-XL Instructions D'origine

All manuals and user guides at all-guides.com
Fig 5
Fig 6
Fig 7
5. Fitting the Workpiece Support (Fig.5)
Workpiece supports can be fitted to both sides of the
machine base if required.
1. Right Hand side. Loosen the support retaining screw
located in the top front of the machines base.
2. Insert the workpiece supports into the retaining holes in
the base. Ensure positive location.
NOTE: Approximately 70mm of the Workpiece Support
should slide into the base to provide positive location.
3. Tighten the retaining screw.
4. Repeat above for the LH side.
6. Fitting the Upper Workpiece Clamp (Fig.6)
Two sockets (one either side) are incorporated into the rear
of the machines fence.
1. Fit the clamp to the retaining socket that best suits the
cutting application, ensuring that it is fully pushed down.
2. Tighten the fence thumbscrew to lock the pillar into the socket.
3. Put the workpiece to be cut onto the saw bed.
4. Adjust the clamp using the thumbscrew and hand-wheel
so that it securely holds the workpiece to the saw bed.
Ensure that the clamp does not foul the blade.
OPERATING INSTRUCTIONS

OPERATION

CAUTION: The Mitre Saw should be inspected (particularly
for the correct functioning of the safety guards) before each
use. Do not connect the saw to the power supply until a
safety inspection has been carried out.
Ensure that the operator is adequately trained in the use,
adjustment and maintenance of the machine, before
connecting to the power supply and operating the saw.
WARNING: To reduce the risk of injury, always unplug the
saw before changing or adjusting any of the machines parts.
Compare the direction of the rotation arrow on the guard
to the direction arrow on the blade. The blade teeth should
always point downward at the front of the saw. Check the
tightness of the arbor screw.
Laser Guide
This saw is equipped with a laser cutting guide. This allows
the operator to preview the path of the blade through the
workpiece. The ON/OFF switch for the Laser Guide is
positioned on the top of the motor housing. (Fig 7)
Avoid direct eye contact, and do not use on material that
could reflect the laser beam.
www.evolutionfury.com
GB
13