Evolution FURY3-XL Instructions D'origine page 12

All manuals and user guides at all-guides.com
®
6. Install the new 255 mm (10") blade. Make sure the
rotation arrow on the blade matches the clockwise rotation
arrow on the upper guard.
NOTE: The blade teeth should always point downward at the
front of the saw.
7. Install the blade washer and arbor screw.
8. Lock the arbor and tighten the arbor screw using moderate
force, but do not overtighten.
9. Replace the guard operating arm and its retaining clip.
(Fig. 1)
10. Ensure the Allen Key is removed and the arbor lock has
released before operating.
11. Ensure the blade guard is fully functional before using
Fig 4
the machine.
NOTE: Spacers and spindle rings should not be used with
this machine and/or blade.
3. Debris collection bag
The Debris Collection Bag should be attached at the debris
extraction port.
1. Slide the frame of the collection bag on to the outlet of the
extraction port, ensuring that it is firmly connected.
2. To release the bag, slide the frame in the opposite direction.
NOTE: To ensure optimal dust collection, empty the dust bag
when it becomes approximately 2/3 full.
WARNING: Before cutting metal materials, the collection
bag should be removed and replaced with a blanking plug.
Reinstate the dust bag when cutting wood.
4. Fitting the Repeat Stop
1. Loosen the repeat stop thumb screws sufficiently to allow
the arms of the workpiece support to slide through the holes
in the repeat stop.
2. Tighten the thumb screws firmly to minimize movement
on the workpiece support. Position the repeat stop
approximately half way along the workpiece support.
3. Attach the workpiece support to the machine base as
detailed below.
NOTE: By loosening the thumb screws the repeat stop can
be adjusted to the required distance from the saw blade
for repetitive cutting operations etc. The repeat stop should
normally be positioned to the RH side of the blade.
12 www.evolutionfury.com