Porsche Mobile Charger Mode D'emploi page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
Electric shock, fire
DANGER
Incorrectly installed electrical sockets can cause
electric shock or fire when the high-voltage battery
is charged using the vehicle charge port.
e
Installation and initial operation of the electrical
socket for the charger may only be carried out by
a qualified electrician. The qualified electrician is
fully responsible for compliance with the relevant
standards and regulations.
e
The cross-section of the supply cable for the
electrical socket is defined in accordance with
the wire length and the locally applicable regula-
tions and standards.
e
Connect the electrical socket used for charging
via a separately fused electric circuit, which
complies with local laws and standards.
e
The charger is designed for use in the private and
semi-public sector (e.g. private property, com-
pany parking lots). In some countries, e.g. in Italy
and New Zealand, mode 2 charging is prohibited
in public areas.
Further information is available from your au-
thorized Porsche dealer or your local electricity
supplier.
e
Unauthorized persons (e.g. playing children)
must not have access to the charger or the vehi-
cle during unsupervised charging.
e
Please read the safety instructions in the instal-
lation instructions and the Owner's Manual.
Electric shock, fire
DANGER
Incorrect handling of the plug contacts can lead to
electric shock or fire.
e
Do not touch the contacts on the vehicle charge
port and charger.
e
Do not insert any objects into the vehicle charge
port or charger.
e
Protect electrical sockets and plug connections
against moisture, water and other liquids.
Flammable or explosive
WARNING
vapors
Components of the charger can cause sparks and
ignite flammable or explosive vapors.
e
To reduce the risk of explosion, –particularly in
garages–, make sure that the control unit is lo-
cated at least 19.7 in. (50 cm) above the floor
during charging.
e
Do not install the charger in potentially explosive
areas.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable pro-
tection against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If the Wall
Charger Connect does cause harmful interference
to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user
is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving radio or televi-
sion antenna.
Increase the distance between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved by
the manufacturer could void the user's authority to
operate the equipment under FCC rules. To meet FCC
RF exposure compliance requirements, the device
must be installed so that it is at least 8 inches (20
cm) from all persons.
Observe the following instructions and recommenda-
tions in order to ensure uninterrupted charging with
the charger:
Before installation, check that the additional
power required to charge a vehicle can be con-
tinuously provided by the currently available do-
mestic installation. Protect the domestic instal-
lation with an energy management system, if
necessary.
The charger must preferably be operated in
grounded power grids. The ground wire must be
correctly installed.
Safety
5

Publicité

Table des Matières
loading

Table des Matières